移机步骤
Relocation steps
1.确定空调移动的位置，管度的长度是否足够。空调的安放位置是否适合，是否符合各种要求等。空调的重新移机也是需要符合一般安装空调位置的要求的。应该勘察好环境位置是否适合转移空调，再准备好需要的材料和器材。包括制冷修理工具一套，以及室内外机的固定用膨胀螺丝等材料。还有需要更新、延长等的管道等等。
1. Determine the moving position of the air conditioner and whether the pipe length is enough. Whether the location of the air conditioner is suitable, whether it meets various requirements, etc. The relocation of the air conditioner also needs to meet the requirements of the general installation position of the air conditioner. We should investigate whether the location of the environment is suitable for the transfer of air conditioning, and then prepare the required materials and equipment. Including a set of refrigeration repair tools, as well as indoor and outdoor units fixed with expansion screws and other materials. There are also pipes that need to be updated, extended, etc.
2.回收制冷剂:把空调器中的制冷剂收集到室外机中去。拆机前应启动空凋器，可用遥控器设定制冷状态，待压缩机运转5-10分钟，制冷状态正常后，用扳手拧下外机的液体管与气体管接口上的保帽，关闭高压管(细)的截止阀门，l分钟后管外JDG金属穿线管 不锈钢链板 隔离墩模具 检查井钢模具 流水槽模具 阶梯护坡模具 护坡砖模具 遮板模具表结露，立即关闭低压管(粗)截止阀门，同的迅速关机，拔下电源插头，用扳手拧紧保险帽，至此回收制冷剂工作完成。
2. Recovery of refrigerant: collect the refrigerant in the air conditioner into the outdoor unit. Before dismantling the machine, start the air conditioner, and use the remote control to set the refrigeration state. After the compressor runs for 5-10 minutes and the refrigeration state is normal, use a wrench to screw off the protective cap on the interface between the liquid pipe and the gas pipe of the external machine, and close the stop valve of the high-pressure pipe (thin). One minute later, the outer surface of the pipe is dewy. Immediately close the stop valve of the low-pressure pipe (coarse), and quickly shut down the machine, and unplug the power plug, Tighten the safety cap with a wrench, and the work of recovering refrigerant is completed.